PDA

View Full Version : New gasket



BGEGUY
03-19-2012, 08:18 PM
Hey fellas I'm new here but not to the egg. I burnt up my gasket and was looking at new ones. What y'all think of the high-que?

SmokyOkie
03-19-2012, 09:42 PM
I don't know about the High Que brand, but if they are made from Nomex, they are prolly good.

Primo
03-20-2012, 06:47 AM
Go and get you some stove rope .Its the best and will last a long time .Only do the bottom section ,no need to do the lid .
Use high temp ultra copper rtv silicone ,made by permatex.
clean bottom surface real well ,then wipe down with mineral spirits ,make sure the grease is gone on the surface.scuff the bottom surface with a wire brush of sorts before applying adhesive.